![]() I started the application and opened and chose the blank board, which is appropriate for the size I'm going to design. The length of the board was 2440 mm(96 inches), the maximum thickness of was 750 mm(29.5 inches), and the maximum width was 560 mm(22 inches). I do not have any knowledge about surfboard design, and I do not want my original design to ruin the final project, so I decided to copy my existing surfboard designįirst, I measured my board dimensions. Monthly subscription($45 / month) available There are other softwears and interfaces were pretty much the same. ![]() ![]() I used AKU Shaper from that software based on this great documentation. I chose a CAD software specialized for surfboard design. surfboard design with 3D software software Also, I designed 2D for the final project's original logo. I am planning to mill the surfboard to the 8th week (make something big) and intend to print the containers 3D in the 5th week. They are surfboards, waterproof containers, fins (optional). ) a possible final project, and post it on your class pageĪs a homework assignment this week, I modeled what I needed for the final project. model (raster, vector, 2D, 3D, render, animate, simulate.This design key will also allow you to make adjustments to the top outline in the Outline tab, as opposed to working from the bottom outline of the board. Show Rocker Upside Down: Flip your design upside down for an alternative design perspective This feature will also remain active in the Top/Bottom tabs: Nose Right: Flip your design the other way for an additional design perspective Point Movement Size: Change the size of the adjust increments for fine tuning critical parts of your designĠ.1 mm = Ultra Fine 1.0 mm = Medium 1.0 Pixel = Heavy movement Nose Right Spot Check: Clear all board information for a clear view of your design. Left/ Right Arrows: Pan an entire design left or right with these arrows Spot Check You may also use the arrow keys on your keyboard. These functions can also be controlled from the Dimensions tab in the toolbar.Īrrow Key Controls: Control the position of your design using these keys. *In the Change Dimensions box, keys can be punched in using a. The corresponding guide at the top allows the shaper to take incremental measurements of a designįt - cm - mm - ft (decimal) - Ft / mm Keysįt-cm-mm-ft (decimal)-ft/mm Keys: These keys are used to toggle between different units of measurements How to use the N Rocker - T Rocker Tool 1:1 Ratio Toolġ:1 Ratio Tool: Used an alternative, zoomed out design perspective. *Use the Up and Down arrow keys to control the movement of the rocker N Rocker: Move the entire Nose rocker up or down using in the Top/Bottom tab T Rocker: Move the entire Tail rocker up or down using this key in the Top/Bottom tab To manually enter points, use the Guide Points tab in the tool bar. To add points, use the Add Guide key in the tool bar. Or to make marks along an outline to plot out a new shape. Undo - Redo Keys: Use the back and forward keys to undo a change or redo a change Add GuideĪdd Guide: Guide points are added to use a reference point from an existing shape. Points can be added in the Outline, Slices, Top, and Bottom tabs *Tip: Zoom In & Place control points close together to create wings, beak noses, and channels. Points must be added at the bottom outline of the design. Zoom Fit: Revert back to full view from the zoom position Add PointĪdd Point: Add additional control points using this key. Zoom Box: Draw a square around the area you want to zoom to work in a closer proximity Startup Guide on How to use AkuShaper toolbar keys Zoom Box
0 Comments
Leave a Reply. |